24
Setting the error behaviour of OUT1 / OUT2
9.5.6
Select [FOU1] and determine the value:
►
[On] = output 1 switches ON in case of an error�
-
[OFF] = output 1 switches OFF in case of an error�
-
[OU1] = output 1 switches irrespective of the error as defined with the
-
parameters�
Select [FOU2] and determine the value:
►
[On] = output 2 switches ON in case of an error, the analogue signal
-
goes to the upper end stop value�
[OFF] = output 2 switches OFF in case of an error, the analogue signal
-
goes to the lower end stop value�
[OU2] = output 2 switches irrespective of the error as defined with the
-
parameters� The analogue signal corresponds to the measured value�
Service functions
9.6
Reading the min./max. values for volumetric flow
9.6.1
Select [HI] or [LO] and press [Set] briefly�
►
[HI] = maximum value, [LO] = minimum value�
Delete memory:
Select [HI] or [LO]�
►
Press [Set] and keep it pressed until [----] is displayed�
►
Press [Mode/Enter] briefly�
►
It makes sense to delete the memories as soon as the unit works under
normal operating conditions for the first time�
Reset all parameters to the factory setting
9.6.2
Select [rES], then press [Set] and keep it pressed until
►
[----] is dis-
played�
Press [Mode/Enter] briefly�
►
The factory setting is listed at the end of the instructions (→ 13 Factory
setting)�
It makes sense to write your own settings in this table before executing the
function�
