IFM Electronic E2D400 Series, User Manual

Page: 59 / 160

E2D400 Series Panel PC
Page 49
Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the onboard RJ-45 connector. Step 0:
4.11.2 Serial Device Connection
The E2D400 Series has two male DB-9 connectors on the bottom panel for serial devices
to be connected. Follow the steps below to connect a serial device to the E2D400 Series
panel PC.
Step 1: Locate the DB-9 connector . The location of the DB-9 connector is shown in
Chapter 2 .
Step 2: Insert the serial connector . Insert the DB-9 connector of a serial device into
the DB-9 connector on the bottom panel. See Figure 4-21 .
Figure 4-21: Serial Device Connector
Step 3: Secure the connector . Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0: