IFM Electronic E2D400 Series, User Manual

Page: 39 / 160

E2D400 Series Panel PC
Page 29
4.7 HDD Installation
To install the HDD, please follow the steps below:
Step 1: Remove the plastic back cover. See Section 4.5 above.
Step 2: Remove the aluminum cover. See Section 5.4.2 .
Step 3: Remove the four HDD bracket retention screws and lift the HDD bracket off the
panel PC.
Step 4: Attach the HDD brackets to the HDD. To do this, align the four retention screw
holes in the both sides of the HDD bracket with the retention screw holes on the
sides of the HDD. Insert four retention screws into the HDD bracket
( Figure 4-5 ).
Figure 4-5: HDD Retention Screws
Step 5: Connect the SATA cable to the rear of HDD and the SATA connector on the
motherboard.
Step 6: Install the HDD by aligning the retention screw holes in the HDD brackets with
the retention screw holes on the chassis. Insert the four retention screws.
Step 7: Replace the aluminum back cover to the chassis.
Step 8: Replace the plastic back cover. Step 0: