UK
Operating instructions AX460
19
0�01
Default value
60�000
Highest value
AVERAGE FILTER
Optional averaging to prevent display fluctuations�
OFF
No averaging
CYCLE FILTER 2
Free-flowing averaging with 2 cycles
CYCLE FILTER 4
Free-flowing averaging with 4 cycles
CYCLE FILTER 8
Free-flowing averaging with 8 cycles
CYCLE FILTER 16
Free-flowing averaging with 16 cycles
OFFSET
With this parameter, the zero point shift / tare of the input is set�
-64�999
Lowest value
0
Default value
+64�999
Highest value
LINEARIZATION
This parameter defines the linearisation function(→ 10 Linearisierung)� The linearisation points are set in
the IN 1 / IN 2 LINEARIZATION menu�
OFF
No linearisation
1 QUADRANT
Linearisation in the 1st quadrant
4 QUADRANT
Linearisation in all 4 quadrants
TOTALIZATION
This parameter activates the totalisation function� Settings are made in the IN 1 / IN 2 TOTALIZATION
menu� The totalisation depends on the selected operating mode (→ 9.5 IN 1 Totalization)�
OFF
No totalisation
ON
Totalisation active
9.4 IN 1 Linearization
In this menu the linearisation points for input 1 are defined� This menu is only
displayed if the corresponding linearisation is selected in the IN 1 PROPERTIES
menu (→ 10 linearisation)�
P1(X) ... P24(X)
X coordinate of the linearisation point
This is the display value which the device generates without linearisation depending on the input signal�
-99999999
Lowest value
0
Default value
+99999999
Highest value