17
SPEED
SLOW SPEED:-Making chappattis/Tea/Re-heating the food/
MEDIMUM:-Vegetable cooking/Parantha/Boiling.
HIGH:-Deep frying/Pressure cooking/
For maximum efficiency from your chimney use the rear burners of your cook top/hob
Turn on the chimney as soon as you start cooking & keep it running for a few minutes after
the cooking.
Regular maintenance & cleaning will enhance the life of the product & will ensure the
good performance.
It's advisable to call qualified & authorized Service person for periodically cleaning
the internal assembly; same would greatly improve the performance of the product.
Note-
if due to any reason if you don't use the chimney, oil/fat may deposed on the filter &
surface of the chimney it may start dripping & can cause the fire also
Note:
- before carrying out the maintenance cleaning or replacing the lamp, disconnect the
chimney from the main supply (remove the plug from the socket.)
Re-circulation Mode
Check that activated charcoal filters are fitted properly, so that the impurities can
be effectively absorbed.
The chimney has to be operated at the second or lowest speed so that sufficient time is
available for the filtration of the air. (Never use high speed) The activated charcoal filters
can't be re-used & needs periodical change. The life of the activated charcoal filters are
about 3 to 4 months. However if the chimney is used more than 4 hours a day & large
amount of oil is used while cooking then filters may require more frequent replacement.
*The charcoal filters have to be changed as soon as they are saturated. They can be easily
replaced by turning them anti clockwise for removing & clockwise to refit them or by
using screw driver to unscrew them for removing them & screwing them to tighten.
(Depending on the models)
*Applicable for the models which can be
installed in the recirculation mode.
NOTE:IN SOFT TOUCH CONTROL,PUSH THE BUTTON AGAIN WILL STOP THE MOTOR .
Hang the entire chimney onto the two
expanding screws, ensure the chimney is level
and vertical.
Step 7:For IFB-GL-14T-60CM/90CM
& IFB-GL-10PL-60CM/90CM
& IFB-GL-6P-60CM/90CM
Step 6:For IFB-GL-14T-60CM/90CM
& IFB-GL-10PL-60CM/90CM
& IFB-GL-6P-60CM/90CM
Mark 4holes in the wall like this picture .Drill
4 holes of 8mm diameter and 60-70mm in depth
in the wall where you marked .Press the 4
expanding tube in to the holes .Tighten the 4
expanding screws of 5x60mm to the expanding
tube,make sure it’s fixed enough and cann’t be
moved.
Expanding screw
Hood hook
10
4x50
Expanding Screw
Expanding Tube
4x50
Expanding Screw
Expanding Tube
Step 8:
1. Draw the upper duct cover up to the
suitable high, mark on the wall two
keyhole of the upper duct cover hook with
pen firstly.
2. Put down the upper duct cover gently, then
drill the keyholes in 50-60mm depth on the
horizontal level using 8mm drill.
3. Press the expanding tube into the holes.
4. Fix the upper duct cover to the wall with
with two 4x50 expanding screws.
5.Install filter.
Step1:
Take out the chimney from the carton box
and remove the filter,then put it on a
horizontal work table gently.Fix the reducer
to the air outlet if needed.
Otherwise use use ST3.9x10 screws to fix
the exhaust pipe into the air outlet make
sure is connected tightly.
IFB-SS-63P-60CM/90CM&IFB-GN-5P60CM/90CM
Shutter
ST3.9x10
Screw
Reducer for
φ
120 out-let
