WAFER-ULT3/ULT4 3.5" SBC
Page 67
4.10 Intel
®
AMT Setup Procedure
The WAFER-ULT3/ULT4 is featured with the Intel® Active Management Technology
(AMT). To enable the Intel® AMT function, follow the steps below.
Step 1:
Make sure the memory socket is installed with a DDR4 SO-DIMM.
Step 2:
Connect an Ethernet cable to the RJ-45 connector labeled
LAN1
.
Step 3:
The AMI BIOS options regarding the Intel® ME or Intel® AMT must be enabled,
Step 4:
Properly install the Intel® Management Engine Components drivers from the
iAMT Driver & Utility directory in the driver CD.
Step 5:
Configure the Intel® Management Engine BIOS extension (MEBx). To get into
the Intel® MEBx settings, press <Ctrl+P> after a single beep during boot-up
process. Enter the Intel® current ME password as it requires (the Intel® default
password is
admin
).
Step 0:
NOTE:
To change the password, enter a new password following the strong
password rule (containing at least one upper case letter, one lower
case letter, one digit and one special character, and be at least eight
characters).
Summary of Contents for WAFER-UTL3
