IEI Technology WAFER-BT, User Manual

Page: 64 / 114

WAFER-BT
P a g e 52
Figure 4-8: SATA Drive Cable Connection
S te p 3: Connect the cable to the SATA disk . Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-8 .
S te p 4: To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable. S te p 0:
4.5.3 S in g le RS -232 Ca b le
The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
S te p 1:
Locate the connector . The location of the RS-232 connector is shown in
Chapter 3 .