IEI Technology KINO-DQM871, User Manual

Page: 76 / 211

KINO-DQM871 Mini-ITX SBC
Page 61
Step 1: Open the SO-DIMM socket handles . Open the two handles outwards as far as
they can. See Figure 4-4 .
Step 2: Align the SO-DIMM with the socket . Align the SO-DIMM so the notch on the
memory lines up with the notch on the memory socket. See Figure 4-4 .
Step 3: Insert the SO-DIMM . Once aligned, press down until the SO-DIMM is properly
seated. Clip the two handles into place. See Figure 4-4 .
Step 4: Removing a SO-DIMM . To remove a SO-DIMM, push both handles outward.
The memory module is ejected by a mechanism in the socket. Step 0:
4.5 PCIe Mini Card Installation
Two PCIe Mini card slots are located on the KINO-DQM871. To install the PCIe Mini card,
please refer to the diagram and instructions below.
Figure 4-5: PCIe Mini Card Installation
Step 1: Insert into the socket at an angle . Line up the notch on the card with the notch
on the connector. Slide the PCIe Mini card into the socket at an angle of about
20º.
Step 2: Push down until the card clips into place . Push the other end of the card
down until it clips into place on the plastic connector. Step 0: