IEI Technology KINO-AQ170, User Manual

Page: 77 / 161

KINO-AQ170 Industrial Motherboard
Page 63
Step 2: Align the SO-DIMM with the socket . Align the SO-DIMM so the notch on the
memory lines up with the notch on the memory socket. See Figure 4-6 .
Step 3: Insert the SO-DIMM . Once aligned, press down until the SO-DIMM is properly
seated. Clip the two handles into place. See Figure 4-6 .
Step 4: Removing a SO-DIMM . To remove a SO-DIMM, push both handles outward.
The memory module is ejected by a mechanism in the socket. Step 0:
4.6 PCIe Mini Card Installation
4.6.1 Full-size PCIe Mini Card Installation
To install a full-size PCIe Mini card, please follow the steps below.
Step 1: Locate the PCIe Mini card slot . See Chapter 3 .
Step 2: Remove the retention screw and standoff for a half-size PCIe Mini card . To
avoid interference of the board circuit, remove the retention screw and standoff
for a half-size PCIe Mini card as shown in Figure 4-7 .
Figure 4-7: Removing the Retention Screw and Standoff for a Half-size PCIe Mini Card
Step 3: Remove the retention screw . Remove the retention screw as shown in
Figure 4-8 .