IEI Technology IVS-110, Manual

Page: 40 / 119

IVS-110 Embedded System
Page 26
3.8 Solid-State Drive Installation
One 2.5” SATA SSD can be installed in the IVS-110. The SATA SSD is installed into a
hard drive bracket attached on the inside of the bottom surface. To install the SSD into the
system, please follow the steps below.
Step 1: Open the bottom cover. See Section 3.4 .
Step 2: The SSD bracket for installing SSD is located on the internal side of the bottom
cover. Remove the four screws shown below to remove the SSD bracket.
Figure 3-9: SSD Bracket Retention Screws
Step 3: Insert a SSD into the bracket until the SSD is firmly connected to the SATA
interface on the bracket.
Step 4: Align the retention screw holes in the SSD with those in both sides of the bracket.
Secure the SSD with the bracket by inserting four retention screws (M3*5) into
the sides of the bracket ( Figure 3-10 ).