IEI Technology ITG-100-AL, User Manual

Page: 27 / 107

ITG-100-AL Embedded System
Page 15

Qualified Personnel : The ITG-100-AL must be installed and operated only
by trained and qualified personnel. Maintenance, upgrades, or repairs may
only be carried out by qualified personnel who are familiar with the associated
dangers.

Air Circulation : Make sure there is sufficient air circulation when installing the
ITG-100-AL. The ITG-100-AL’s cooling vents must not be obstructed by any
objects. Blocking the vents can cause overheating of the ITG-100-AL. Leave
at least 5 cm of clearance around the ITG-100-AL to prevent overheating.

Grounding : The ITG-100-AL should be properly grounded. The voltage feeds
must not be overloaded. Adjust the cabling and provide external overcharge
protection per the electrical values indicated on the label attached to the back
of the ITG-100-AL.
3.3 Installation and Configuration Steps
3.3.1 Hard Disk Drive (HDD) Installation (ITG-100-AL-E1 only)
WARNING:
The optional USB 2.0 cable cannot be used at the layer where the HDD
drive bay is located.
To install the hard drive, please follow the steps below:
Step 1: Remove the bottom panel by removing the two retention screws from the bottom
panel ( Figure 3-1 ).