IEI Technology IBX-700 Series, User Manual

Page: 152 / 218

IBX-700 Integrated Service Computer
Page 134
Step 8:
Remove the power module.
Step 0:
8.4.3.2 Power Module Installation
To install the new power module, please follow the steps below.
Step 1:
Install the new power module into the system.
Step 2:
Reinsert the four, previously removed power module retention screws.
Step 3:
Reconnect the following cable connectors (
Figure 8-11
):
Motherboard ATX connector
HDD power connector
ODD power connector
Power socket and terminal block connector
Step 4:
Reinstall the HDD and the ODD.
Step 5:
Replace the cover case. Once replaced reinsert the two previously removed
thumb screws. (
Figure 8-12
)
Step 6:
Reconnect the power cable to either the terminal block or +12 V socket
Step 7:
Power up the system.
Step 0:
8.4.4 DIMM Replacement
To replace the DIMM please follow the steps below.
Step 1:
Remove the cover case. See
Section 8.3.1
.
Step 2:
Remove the ODD. See
Section 8.4.5.1
Step 3:
Locate the DIMM. Push the white clips on the side of the DIMM down. The
DIMM is dislodged from the DIMM socket.
Step 4:
Insert the new DIMM. Properly align the DIMM pins with the socket and the
gently push the DIMM into the DIMM socket until the white side handles close
(
Figure 8-13
).
Step 0: