IEI Technology IBX-700 Series, User Manual

Page: 147 / 218

IBX-700 Integrated Service Computer
Page 129
Step 3:
Reinstall the HDD into the IBX-700 by aligning the retention screw holes in the
top of the HDD bracket with the retention screw holes on the chassis. Insert the
four previously removed retention screws into the top of the HDD bracket
(
Figure 8-5
).
Step 4:
Reconnect the following cable connectors (
Figure 8-6
):
SATA connectors (on the motherboard)
Power connectors (on the power module)
8.4.2 Motherboard Replacement
POS motherboard replacement includes the following two procedures:
Step 5:
Removing the malfunction motherboard
Step 6:
Installing the replacement motherboard
Step 0:
8.4.2.1 Motherboard Removal
To remove the POS motherboard, please follow the steps below.
Step 1:
Power down the system.
Step 2:
Disconnect all rear panel peripheral device connectors.
Step 3:
Remove the CF module (if installed) from the rear panel of the IBX-700.
Step 4:
Remove the two VGA connector retention screws, two parallel connector
retention screws and the eight serial port retention screws on the rear panel.
(
Figure 8-8
)