IEI Technology HYPER-AL series, User Manual

Page: 51 / 109

HYPER-AL SBC
Page 39
4.3 SO-DIMM Installation
To install an SO-DIMM, please follow the steps below and refer to Figure 4-1 .
Figure 4-1: SO-DIMM Installation
Step 1: Locate the SO-DIMM socket . Place the board on an anti-static mat.
Step 2: Align the SO-DIMM with the socket . Align the notch on the memory with the
notch on the memory socket.
Step 3: Insert the SO-DIMM . Push the memory in at a 20º angle. (See Figure 4-1 )
Step 4: Seat the SO-DIMM . Gently push downwards and the arms clip into place. (See
Figure 4-1 )
4.4 M.2 Module Installation
To install an M.2 module, please follow the steps below.
Step 1: Locate the M.2 module slot. See Chapter 3 . Remove the on-board retention
screw.
Step 2: Line up the notch on the module with the notch on the slot. Slide the M.2 module
into the socket at an angle of about 20º ( Figure 4-2 ).