AFL3-08A-BT Panel PC
Page 33
NOTE:
When purchasing the cabinet/rack installation bracket, make sure it is
compatible with both the AFL3-08A-BT flat bezel panel PC and the
rack/cabinet into which the AFL3-08A-BT is installed.
Step 1:
Slide the rear chassis of the AFL3-08A-BT panel PC through the rack/cabinet
bracket until the frame is flush against the front of the bracket (
Figure 3-17
).
Figure 3-17: Rack/Cabinet Bracket Installation
Step 2:
Insert a M5*50 screw into the screw hole on the side of the rack mounting
bracket. Then, install the following components onto the screw in sequence.
See
Figure 3-15
.
Sequence Item
Photo
Instruction
1 Spring
Install a spring onto the screw.
2 Nut
Tighten a nut until the spring is
compressed enough for plastic cap.
3 Plastic
cap
Tighten a plastic cap onto the end of
screw thread.
