IEI Technology AFL2-12A-D525 Series, User Manual

Page: 53 / 180

AFL2-12A-D525 Series Panel PC
Page 53
Step 3: To secure the bracket to the AFL2-12A-D525, insert the retention screws into the
screw holes and tighten them. Step 0:
4.9.3 Arm Mounting
The AFL2-12A-D525 is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 100mm interface pad. To mount the AFL2-12A-D525 on
an arm, please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 75 mm or 100 mm interface pad. If the mounting arm is not
VESA compliant it cannot be used to support the AFL2-12A-D525 flat bezel
panel PC.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat bezel
panel PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
flat bezel panel PC ( Figure 4-14 ).