IEI Technology AFL-W10A-N270, User Manual

Page: 66 / 158

AFL-W10A-N270 User Manual
Page 66
BIOS SETUP UTILITY
Main Advanced PCIPNP Boot Security Chipset Power Exit
Primary IDE Master

Device :Not Detected

Type [Auto]
LBA/Large Mode [Auto]
Block (Multi-Sector Transfer) [Auto]
PIO Mode [Auto]
DMA Mode [Auto]
S.M.A.R.T. [Auto]
32Bit Data Transfer
[Enabled]
Select the type of device
connected to the system

Select Screen
 
Select Item
Enter Go to SubScreen
F1 General
Help
F10 Save and Exit
ESC Exit
v02.61 ©Copyright 1985-2006, American Megatrends, Inc.
BIOS Menu 5: IDE Master and IDE Slave Configuration

Auto-Detected Drive Parameters
The “grayed-out” items in the left frame are IDE disk drive parameters automatically
detected from the firmware of the selected IDE disk drive. The drive parameters are listed
as follows:

Device
: Lists the device type (e.g. hard disk, CD-ROM etc.)

Type
: Indicates the type of devices a user can manually select

Vendor
: Lists the device manufacturer

Size
: List the storage capacity of the device.

LBA Mode
: Indicates whether the LBA (Logical Block Addressing) is a
method of addressing data on a disk drive is supported or not.

Block Mode
: Block mode boosts IDE drive performance by increasing the
amount of data transferred. Only 512 bytes of data can be transferred per
interrupt if block mode is not used. Block mode allows transfers of up to 64 KB
per interrupt.

PIO Mode
: Indicates the PIO mode of the installed device.

Async DMA
: Indicates the highest Asynchronous DMA Mode that is
supported.

Ultra DMA
: Indicates the highest Synchronous DMA Mode that is supported.

S.M.A.R.T.
: Indicates whether or not the Self-Monitoring Analysis and
Reporting Technology protocol is supported.