IEI Technology ACT-412A-N270, User Manual

Page: 41 / 133

ACT-412A-N270 User Manual
Page 41
2.11.1 Wall Mounting
To mount the ACT-412A-N270 onto the wall, please follow the steps below.
Step 4:
Select the location on the wall for the wall-mounting bracket.
Step 5:
Carefully mark the locations of the four screw holes in the bracket on the wall.
Step 6:
Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 7:
Align the wall-mounting bracket screw holes with the pilot holes.
Step 8:
Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (
Figure 2-12
).
Figure 2-12: Wall-mounting Bracket
Step 9:
Insert the four monitor mounting screws provided in the wall mounting kit into the
four screw holes on the real panel of the ACT-412A-N270 and tighten until the
screw shank is secured against the rear panel (
Figure 2-13
).
Step 10:
Align the mounting screws on the rear panel with the mounting holes on the
bracket.
Step 11:
Carefully insert the screws through the holes and gently pull the monitor