35
0
1
2
3
4
5
6
7
8
FULL ASCII ( Code 39 ) NUMERIC TABLE
9
SETTING PROCEDURE
APPENDIX 1
. P023$
RESET
Please note that when Min Lenght and / or Max Lenght are
enabled, the scanner will only read bar codes that fall into
those lenght parameters. Bar codes shorter or longer than
specified will not be read. The default lenghts for these are
indicated in parentheses under the Min and Max bar codes
for each symbology.
NOTES:
1. The scanner will beep three times as a reminder that a
setting is not yet complete.
2. If you make a mistake, forget a step, etc., Scan RESET
to start again.
MIN / MAX LENGHT
STEP 1 - Scan: MIN LENGTH / MAX LENGTH
STEP 2 - Scan : Two digits from Appendix 1.
STEP 3 - Scan: MIN LENGTH / MAX LENGTH
Summary of Contents for Econoscan
