Are you setup for the right Interface?
Is the proper symbology enabled?
Sympton ---- The LED lighting is stuck ,and
no
function at all, even triggered
the scanner
Solution ----- Set the Scanner to Default condition,
and
choose the right interfaces
CONFIGURATION SETUP
TROUBLE SHOOTING
-- GROUP 45 --
61
Are you set up for the right interface? Did you select the Keyboard
Wedge cable but set the scanner for RS-232 or Wand Emulation?
Or did you change the Keyboard cable to RS-232 but forget to set
the scanner interface to RS-232 as well?
Set the scanner to its default settings, then selectthe correct interface
based upon the cable and input you are using.
Each bar code symbology can be individually enabled or disabled.
It is suggested that you enable only those that you will be scanning,
thereby eliminating the possibility of misreads from the scanning
of other symbologies.
Does the selected the bar code symbology configuration
match the bar code(s) being read?
Scanned data from each bar code symbology can be restricted to
eliminate the scanning of unused symbologies. The restrictions
are individually set for eachsymbology.
Summary of Contents for Econoscan
