Page 15
Introduction
There are 3 ways to program (configure) the Engine, Code Programming, Command Programming, and
QuickSet Programming.
Code Programming
The Engine reads a set of specially encoded barcodes to program features. In the following sections, we will
explain the options and features available and provide the barcodes to program them.
This method of programming the Engine is most straight forward. However, it requires manually readings of
each barcode. As all manual operations, errors are more likely to occur.
Command Programming
The Host can send the Pro CMD strings (see the chapter of Software Interface) to program the Engine. In the
following sections, the Pro CMD strings will be included with the barcodes for Code Programming.
A fixture, could be used to
program the Engines before they are installed into your equipments or systems.
Another alternative is to design the configuration capability in your equipments or systems.
This method of programming the Engine could be automated. A software program can be developed to
download all the configuration data to the Engine.
Note: The programming results are restored in non-volatile memory. They will not be lost when the Engine is
powered off.
Programming the Engine
