IDS 816, User Manual

Page: 15 / 28

IDS816 User Manual 700-283-01H Issued January 2009
15
11. 11. 11. 11. U U U User Codes ser Codes ser Codes ser Codes
The IDS 816 Alarm Panel has 32 programmable user codes. By default, user code 1 is the Master User
Code that contains a pre-programmed 4-digit code of 1234.
NOTE
NOTE NOTE
NOTE:
: :
:
User codes may be 4 (default) or 6 digits long (with default code of 123456). This is a programmable
feature. Check with your installer to verify which option has been programmed.
11.1
11.1 11.1
11.1 Adding, Deleting and Editing User
Adding, Deleting and Editing User Adding, Deleting and Editing User
Adding, Deleting and Editing User C
C C
Codes
odes odes
odes
Hold down the [*] key until the beep,
then enter [MASTER USER CODE] [*] [PROGRAMMABLE OPTION] [*]
The IDS 816 Panel has a friendly programmable interface that allows you to add, modify or delete user
codes. See Table 1 for a summary of programmable options. The programmable interface is accessed
by entering the
USER PROGRAMMING MODE.
Table 1 User Programming Options
Options Options Options Options Summary of Programmable Options Summary of Programmable Options Summary of Programmable Options Summary of Programmable Options
Option 0 Allows for the addition of new user codes.
Option 1
Allows editing of the user name displayed by LCD keypads.
This option is only applicable if LCD keypads are installed .
Option 2
Allows editing of a selected user code.
Note that the user code properties are not edited, only the user code itself.
Option 3
Allows viewing of the user code slot number for a selected code.
There are 32 available user code slots.
Option 4
Allows editing of the user code properties for a selected user code.
This is a bit mapped menu.
Option 5
Allows the allocation of a selected user code to a designated partition(s).
This is a bitmapped menu.
Option 8 Adding User Remotes.
Option 9 Deleting a User Code.
Option 10 Allows the deletion of a user code using the user code slot number.
Option 11 Allows viewing of a user name if the slot number is known.
12.
12. 12.
12. User Program Mode
User Program Mode User Program Mode
User Program Mode
1.
Ensure that the panel is not armed.
2. Hold down the [*] key until the keypad buzzer sounds.
3. The ARMED and READY indicators will flash alternately.
4. Enter a [MASTER USER CODE]. The factory default is 1234 . Should the [MASTER USER
CODE] be defaulted to six digits, it will be 123456
.
Press the [*] key. A valid entry will be
confirmed by a long beep.
5. If steps 1 to 4 are performed correctly, the READY indicator will flash. If an invalid code was
entered, the keypad buzzer will give an error beep. (3 short beeps). If the error beep occurs, press
the
[#] key (this clears all previous entries) and repeat steps 2 to 5.
6. Select a programmable option from Table 1.