IDS 400, User Manual, Page: 19 / 28

IDS400 USER MANUAL NO. 700-204-01A ISSUED NOV 2000 VER 1.01 19
IDS400 USER MANUAL
followed by the [
-
] key.
4. The
ARMED
and
READY
indicators will begin to flash
simultaneously indicating that the correct master code was
entered. If an invalid code was entered the keypad will beep three
times.
5. Enter the [
USER CODE NUMBER
] you wish to change (1-15)
followed by the [
-
] key.
6. Enter the new 4 digit [
USER CODE
] and press the [
-
] key.
7. Repeat steps 6-8 to enter or change other user codes.
8. Once all the codes are programmed, press the [#] key to exit.
11.2 Deleting User Codes
Follow steps 1-6 of the previous procedure but only press the [
-
] key
in step 7. That particular code will be deleted.
12. Stay Zones
Stay zones are those zones which are bypassed automatically when
the system is
STAY ARMED
. To avoid triggering the alarm, zones
such as the bedroom, or other areas which require access, must be
bypassed - this is done automatically when you stay arm. These
zones must be programmed before you
STAY ARM and need only be
programmed once.
12.1 To Program Stay Zones
Summary: [
3] + [
-
] + [ZONE NUMBER] + [#]
1. Hold down the [3] key until the audible indicator sounds.
2. Press the [
-
] key followed by the [
NUMBER
] corresponding to
the zone you wish to be a STAY zone.
3. The relevant zone indicator will illuminate.
4. Press the [#] key to exit the stay zone programming mode.