IDS 400, User Manual, Page: 14 / 28

14 IDS400 USER MANUAL NO. 700-204-01A ISSUED NOV 2000 VER 1.01
IDS400 USER MANUAL
4. The alarm will arm immediately and the remote
ARM
indicator
will illuminate.
5. If programmed to do so, the siren will sound briefly - verify with
your installer.
NOTE:
If a remote control is used, it is advisable to have the siren sound on
arm and disarm function enabled.
6. Zone Bypassing
L
The term
BYPASS
is used to describe a zone that has been de-
activated; i.e. violations in bypassed zones will not cause an
alarm.
L
It is used when:
L
access is needed to part of the protected area while the
system is armed, e.g. you wish to leave a window open.
L
zones which are temporarily out of service due to damaged
wiring or a faulty sensor.
L
Zones cannot be bypassed once the system is armed.
L
Bypassed zones are automatically cancelled each time the
system is disarmed and must be re-bypassed before the next
arming.
6.1 To Bypass a Zone
[
-
] + [ZONE NUMBER]
1. Press the [
-
] key (while bypassing zones, violated zones will be
flashing).
2. Press the number corresponding to the zone you need to by-
pass e.g. the [2] key if you wish to bypass zone 2.
3. The relevant zone indicator will illuminate to indicate that the zone
is now bypassed.
4. Repeat steps 1 and 2 to bypass any other zones.
NOTE:
Some zones may be programmed to function in a manner which does
not permit bypassing e.g. Panic zones.