26
8.1
DESCRIPTION OF THE SAFETY CHECKS
The high pressure washer is equipped with a watertight control panel where there is the ON-OFF switch (
P
)
and the electrical connections to the motors.
8.2
DESCRIPTION OF THE OPERATIONS TO BE CARRIED OUT AND FUNCTIONING
After carrying out all the operations provided in section 5.7 INSTALLATION AND CONNECTION / CONNEC-
TION, to prepare the system for use:
1. Turn on the ADI sanitation system by turning the main switch of the pumping module to the ON
position.
2. To turn off the ADI sanitation system, turn the main switch of the pumping module to the OFF po-
sition.
WARNING!
CARE AND ATTENTION MUST BE TAKEN WHEN USING THE PRESSURE WASHER. THE MACHINE MUST
BE USED ONLY BY AN OPERATOR WHO HAS BEEN CORRECTLY INSTRUCTED IN ITS USE. DO NOT
ALLOW ANYONE ELSE TO USE THE PRESSURE WASHER WITHOUT FIRST VERIFYING THAT THEY HAVE
BEEN PROPERLY TRAINED IN ITS USE, AND THAT THEY HAVE READ THIS MANUAL AND FULLY UN-
DERSTOOD THE INSTRUCTIONS FOR USE AND THE SAFETY REGULATIONS.
USE WITH CHEMICAL PRODUCTS
The plant was designed for use with chemical products recommended by the manufacturer. The use of
non-recommended chemicals can adversely affect the safety and correct operation of the machine.
WARNING!
AFTER THE USE OF DETERGENTS OR DISINFECTANTS IT IS USEFUL TO RUN THE MACHINE FOR A FEW
MINUTES WITH CLEAN WATER, TO RINSE OUT THE CIRCUIT.
WARNING!
DO NOT USE THE PUMPING MODULE TO VACUUM PRODUCTS CONTAINING SOLVENTS, PETROL, DI-
LUENTS, ACETONE, COMBURABLE OILS, TOXIC OR IRRITATING PRODUCTS SINCE THE VAPORS ARE
HIGHLY FLAMMABLE, EXPLOSIVE, TOXIC OR IRRITATING.
CAREFULLY READ THE INSTRUCTIONS AND WARNINGS ON THE LABEL OF THE DETERGENT USED.
8.3 REGULATION
The machine is tested and tested by the manufacturer and the operating pressure of the machine is cali-
brated before being shipped. Under NO circumstances is it allowed to change the calibration of the pres-
sure regulating valve.
8 - USER INSTRUCTIONS
Summary of Contents for Adi
Page 30: ...30 NOTES ...
Page 31: ...31 NOTES ...
