Service Manual ToFscan - Rev G
5
Main menu, Display screen
The various
stimulations
(or menu)
Stimulation current
selected
Switch off
Sensor cable
connection
Patient/Electrode
impedance
Battery level
Time expired since the last
measurement
Settings
Menu selection
The menus, options and various tests are accessed using the selection wheel on the front of the
ToFscan. The user navigates through the various menus by turning the wheel (clockwise or anti-
clockwise). A selection is made by pressing and releasing the wheel. To start a test or an electrical
stimulation, to access the settings or switch off the device press and hold the wheel for 2 seconds.
Battery / AC power supply operation
The ToFscan is battery operated. It can run for almost a month before charging is needed (for
further information please see the battery chapter). The battery is charged via the AC power supply
provided.
The AC power supply unit can be used as a permanent mains power supply unit. The ToFscan
will operate via its mains power supply unit without using the battery. In this operating mode, the
ToFscan displays the results and all information continuously. It will go into energy-saving mode 2
hours after it was last used or the last measurement was taken.
When the ToFscan operates on battery, it will go into energy-saving mode if the “ECO” mode is
activated (for further information see the ECO function in the ToFscan user manual settings menu).
Note:
Position ToFscan and its power supply charger in a way to make it to unplug easily if needed.
Before use, ensure that the battery is fully charged.
In case of any power supply charger malfunctions, do not replace by or use a non IDMED power
supply charger.
