IDK MSD-72 Series, User Manual

Page: 99 / 150

MSD-72 Series User’s Guide
99
[Table 9.20] Setting items of control command
Item
Setting
Description Range
COM CC CEC
RECV DISPLAY yes no no Set whether received data is displayed
or not.
OFF [Default]
ASCII
HEX
DELIMITER
*1
yes no no Set the delimiter to be sent at the end of
the received data.
“NONE”: delimiter is not checked and all
received data within the set timeout will
be valid.
Value other than “NONE”: delimiter is
checked and data received before
delimiter will be valid.
NONE [Default]
00 to FF (Hex)
RCV CHECK
*2
yes no no Set whether reply command that may
be returned is checked or not.
CHECK
NOT CHECK [Default]
TIME OUT
*3 *4
yes no no Set the timeout time for reply command
to a sent command.
0ms to 99s999ms
[Default]: 0ms
RETRY
*3 *4
yes no no Set the number of retries to resend the
same command again if no valid
response is replied.
0 to 99 (times)
[Default]: 0
INTERVAL
*3 *4
yes no no Set the retry interval to resend the
command.
0ms to 99s999ms
[Default] 0ms
ERROR
*3 *4
yes no no Set whether the next command is to be
executed or not if no valid response is
replied, even after completing retry for
the set number of retries.
STOP [Default]
EXEC: continue
Contact closure
control
no yes no Set the contact closure control.
If you select “toggle operation”, it can
invert the condition of contact
(open/close).
-: not control [Default]
OFF: contact open
ON: contact close
TGL: toggle
Palse width no yes no Set the time of returning its original
condition when you control the contact
closure.
NONE: eternity [Default]
100ms to 9990ms (by 10ms)
HDMI CEC
control
*7
no no yes Set the CEC control for the sink devices
connected to OUT1 to OUT4.
-: not control [Default]
POWER OFF
POWER ON
Process for CEC
error
no no yes
Set whether the next command is
executed or not if no response is replied
from the sink device that is controlled
with CEC.
STOP [Default]
EXEC: continue
MEMO yes yes yes
Register a note up to 14 characters.
The registered note is displayed when
the control command is executed.
20 to 7D in ASCII codes
except for 2C (,)
[Default] 20 (space)