HDC-TH100WPJ User Guide
12
[Table 4.2] HDC-TH100WPJ features (Cont’d)
#
Feature
Description
④
POWER LED
Shows the power status
Illuminates in green : Powered
Does not illuminate : Not powered
⑤
LINK LED
Shows the connection status between the HDC and HDBaseT receiver
Illuminates in green : The receiver is connected
Blinks in green (0.5-second interval) : The receiver is in standby state
Does not illuminate : No connection
⑥
HDCP LED
Shows the HDCP status
Illuminates in green : HDCP compliant
Blinks in green : HDCP incompliant
Does not illuminate : No video signal
⑦
RESET button
Resets the HDC and then re-establish the connection to HDBaseT
receiver
⑧
LONG REACH switch
Enables/disables long reach mode of HDBaseT output for up to 1080p
(24 bit) or dot clock 148 MHz
ON : Enables long reach mode (Up to 492 ft. (150 m))
OFF : Disable long reach mode (Up to 328 ft. (100 m))
⑨
DC 12V IN (power input)
connector
Connector for DC 12 V power supply
When using PoH, do not use DC 12V power supply
【
See: 6.1 Power supply
⑩
Frame ground
Use for bonding chassis to local ground. An M3 screw is used.
⑪
Screw hole
Hole for installing the HDC to a switch box or the like
⑫
Screw hole
Hole for attaching a 2-gang decorator wallplate
Note:
For Long reach mode, up to 1080p (24 bit) resolutions are supported when using IDK
’
s HDBaseT products
supporting 328 ft. (100 m).
