FDX-08 User Guide
37
8.2.2 No-signal input monitoring [INPUT SIGNAL CHECK]
If you change the EDID settings of the FDX or power the FDX off/on, the source device may not output a
video signal. Use this menu to set the monitoring time which is from when a source device stops outputting
signal to when the FDX requests the source device to output video signal.
Changing EDID
ON
OFF
Requesting source device to
output video signal
Monitoring
Hot plug
ON
OFF
Video signal from
source device
[Fig. 8.1] Monitoring absence of input
Menu
INPUT SETTING → INPUT SIGNAL CHECK
Setting for
Each input connector (IN1 to IN8, ALL)
Setting value
OFF
3Sec to 15Sec [Default] 10 sec.
Notes:
・
If you are using the monitor power-saving or dual monitor features on your PC, set this feature to “OFF”.
This will avoid unpredictable operation.
・
When using this feature, ensure that the “monitoring time” is set for a value greater than the amount of
time needed for the source to provide an output signal.
・
Only channels of input board can be selected in this menu.
Channels in which an SDI input board cannot be selected.
[Fig. 8.2] Repeating output signal setting
Changing EDID
Monitoring
ON
OFF
Monitoring
Monitoring
Outputting source device
’
s video
Video signal from
source device
Requesting source device to output signal
