iDirect Evolution 8000 Series, Installation And Safety Manual

Page: 37 / 90

iDirect Evolution 8000 Series Satellite Router Installation and Safety Manual 23
Defining the e8350 Satellite Router Rear Panel
A description of each connector and indicator is shown in Table 9 .
The RJ-45 Console port pin assignments are listed in Table 10 .
Table 9. e8350 Satellite Router Connectors
Label Connector Type Interface and Purpose
10 MHz 75 ohm, BNC External 10 MHz clock
TX Out 75 ohm, F-Type L-band transmit signal to Block Up Converter
(BUC) capable of 10 MHz reference and +24
VDC, 3.5A (or +48 VDC, 3A) maximum power
supply to BUC
RS-232 HD-15 Female Serial interface connection used for antenna
pointing
RX Out 75 ohm, F-Type with
DC Blocked
Termination Monitoring of the receive signal from LNB
output, -10 dB nominal composite, buffered
RX In 75 ohm, F-Type L-band receive signal, capable of 10 MHz
reference and DC power to LNB
USB USB Universal Serial Bus interface connection
CONSOLE RJ-45 RS-232 servicing serial connection console to
PC or laptop
LAN A RJ-45 Category-5 STP or UTP cable, 10/100
Base-T Ethernet LAN port connects the e8350
and e800 iCONNEX Satellite Router models to
the customer LAN hub/switch
LAN B RJ-45 Category-5 STP or UTP cable, 10/100
Base-T Ethernet LAN port connects the e8350
and e800 iCONNEX Satellite Router models to
the customer LAN hub/switch
100-240 V~
4A/2A
50/60 Hz IEC-320-C14 AC input
Table 10. RJ-45 Pin Assignments
PIN SIGNAL NAME DESCRIPTION
1 Not Connected Do not connect
2 Reserved (Tx) Do not connect
3 Transmit Data (TxD) RS-232 voltage level compliant transmit data
signal for debug use only
4 Ground (GND) Ground
5 Ground (GND) Ground