iDiPOS TP-80, Program Manual, Page: 32 / 54

31
Decimal 29 47 m
[Range] 0 ≤ m ≤ 3, 48 ≤ m ≤ 51
[Description] Prints a downloaded bit image using the mode specified by m .
m selects a mode from the table below:
m Mode Vertical Dot Density (DPI) Horizontal Dot Density (DPI)
0, 48 Normal 200 200
1, 49 Double-width 200 100
2, 50 Double-height 100 200
3, 51 Quadruple 100 100
[Details]
•
This command is ignored if a downloaded bit image has not been defined.
•
In standard mode, this command is effective only when there is no data in the
print buffer.
•
This command has no effect in the print modes (emphasized, double-strike,
underline, character size, or white/black reverse printing), except forupsidedownprinting
mode.
•
If the downloaded bit-image to be printed exceeds the printable area, the
excess data is not printed.
[Reference] GS *
48. GS :
[Name] Start/end macro definition
[Format] ASCII GS :
Hex 1D 3A
Decimal 29 58
[Description] Starts or ends macro definition.
[Details]

Macro definition starts when this command is received during normal operation.
Macro definition ends when this command is received during macro definition.

When GS ^ is received during macro definition, the printer ends macro
definition and clears the definition.

Macro is not defined when the power is turned on.

The defined contents of the macro are not cleared by ESC @ . Therefore,
ESC @ can be included in the contents of the macro definition.

If the printer receives GS : again immediately after previously receiving GS :
the printer remains in the macro undefined state.

The contents of the macro can be defined up to 2048 bytes. If the macro
definition exceed 2048 bytes, excess data is not stored.
[Reference] GS ^
49. GS B n
[Name] Turn white/black reverse printing mode
[Format] ASCII GS B n
Hex 1D 42 n
Decimal 29 66 n
[Range] 0

n

255