iDiPOS TP-80, Program Manual, Page: 22 / 54

21
Decimal 27 99 51 n
[Range] 0

n

255
[Description] Selects the paper sensor(s) to output paper end signals
•

Each bit of n is used as follows:
[ Note ]

It is possible to select multiple sensors to output signals. Then, if any of the sensors detects a
paper end, the paper end signal is output.

The command is available only with a parallel interface and is ignored with a serial interface.

Sensor is switched when executing this command. The paper end signal switching be delayed
depending on the receive buffer state.

If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper sensor
outputting paper-end signals

If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper sensor outputting
paper-end signals.

When all the sensors are disabled, the paper end signal always outputs a paper present status.
[ Default ] n = 0
35. ESC c 4 n
[Name] Select paper sensor(s) to stop printing
[Format] ASCII ESC c 4 n
Hex 1B 63 34 n
Decimal 27 99 52 n
[Range] 0

n

255
[Description] Selects the paper sensor(s) used to output paper short singnal.
using
n as follows:
Bit Off/On Hex Decimal Function
0
Off 00 0 Paper roll near-end sensor disabled
On 01 1 Paper roll near-end sensor enabled
1
Off 00 0 Paper roll near-end sensor disabled
On 02 2 Paper roll near-end sensor enabled
Bit Off/On Hex Decimal Function
0
Off 00 0 Paper roll near-end sensor disabled
On 01 1 Paper roll near-end sensor enabled
1
Off 00 0 Paper roll end sensor disabled
On 02 2 Paper roll near-end sensor enabled
2
Off 00 0 Paper roll end sensor disabled
On 04 4 Paper roll near-end sensor enabled
3
Off 00 0 Paper roll end sensor disabled
On 08 8 Paper roll near-end sensor enabled
4-7 - - - Undefined