Idex Pulsafeeder MPC Vector, Installation, Operation & Maintenance Manual

Page: 70 / 114

64
11.1 Motor Parameter Setup and Calibration
1. Navigate to the CALIBRATION menu and press ENTER, and scroll (UP/DOWN) to the MOTOR
PARAM option. The starting display will be:
C A L I B R A T I O N
M O T O R P A R A M
2. Press the ENTER key
M O T O R R A T E D R P M
< 1 7 5 0 >
3. Use UP and DOWN arrows to adjust value as required, then press the ENTER key
M O T O R C U R R E N T
< 1 . 2 >
4. Use UP and DOWN arrows to adjust value as required, then press the ENTER key
M O T O R V O L T A G E
< 2 3 0 >
5. Use UP and DOWN arrows to adjust value as required, then press the ENTER key
M O T O R F R E Q U E N C Y
< 6 0 >
6. Use UP and DOWN arrows to adjust value as required, then press the ENTER key
M O T O R P W R F A C T O R
< 0 . 8 0 >
7. Use UP and DOWN arrows to adjust value as required, then press the ENTER key
E N T E R T O S T A R T
8. Press the ENTER key ( Note: calibration may take up to a minute)
C A L I B R A T I N G
9. The last screen will show
M O T O R P A R A M
C A L I B R A T E D
10. Upon completion of the routine, remove power from the MPC VECTOR controller for one minute, and then
re-apply power to complete the process.