184
G.
Touch Home button.
H.
Cycle SAM system power.
5.6.
Temperature Sensor Calibration
To correct the SAM temperature readout (calibrate temperature), perform the following.
A.
On SAM Pump Controller, touch and hold System Options button until loading
icon completes circle and Menu screen is displayed.
B.
Touch Password Entry button.
C.
Enter Temperature Calibration password. See Table 3 (page 36).
D.
Select temperature location as follows. See Figure 154.
To select gearbox temperature sensor, touch Gearbox button.
(top-most right-hand button; gear encircling a thermometer)
To select pump temperature sensor, touch Pump button.
(middle right-hand button; pump encircling a thermometer)
Figure 154. Temperature Calibration Screen (Pump Shown)
E.
Using digits pad, enter correct temperature (form test equipment or calibrated
thermometer) into Desired Temperature.
F.
Touch enter button (
).
G.
Touch Save button (disk icon at bottom right of screen).
H.
Touch System Options Menu button. (Exits the screen.
5.7.
Voltage Calibration
As part of the voltage calibration, the voltage warning, voltage error, and battery offset can be
set. To calibrate the SAM voltage read out, perform the following.
A.
On SAM Pump Controller, touch and hold System Options button until loading
icon completes circle and Menu screen is displayed.
B.
Touch Password Entry button.
C.
Enter Voltage Calibration password. See Table 3 (page 36).
D.
Select Battery Offset Voltage (or other value requiring change) as follows.
If required, touch row to select Voltage Warning. (Set by NFPA/AHJ.)
If required, touch row to select Voltage Error. (Set by NFPA/AHJ.)
Touch Battery Voltage Offset row.
Summary of Contents for Hale Sam
