NOTE:
Before assembly consult a suitably qualified healthcare professional regarding the correct height
adjustment for maximum support, and correct brake activation.
1.Check all wheels are in good working order and roll freely.
2.Check the basket is securely fixed and all fixing buttons are tightly fastened
3.To assemble; insert the front & rear wheels, using the button clips on the rear wheels and the "C" Clips on
the front to position. Loosely insert the handlebars, do not fix the handlebars at this stage.
4.Fit the back rest into the frame and secure with snap clips.
5.To set the seat height, with the rollator frame open, push down on the seat until all four wheels are
extended and the cross member is in line, as shown in diagram 1. The seat height can be adjusted by sliding
the wheel assemblies in the frame tubes and positioning using the button & "C" clips. Make sure that all the
clips "click" into position and all four wheels make contact with the floor and the rollator is stable.
6.Set the correct height of the handlebars, as follows:
· Stand upright behind the rollator with your shoulders relaxed and your arms by your side,
· looking straight ahead.
· In this position, the handgrips of the rollator (see diagram 1) should be adjusted to a height level with
your wrists.
· This will position your arms at an approximate 20º to 30º bend when using the rollator.
· Check that the holes in the handle bars and the frame are aligned.
· Place the supplied Hand bolts through the aligned holes in the handlebar and frame, and hand tighten
firmly - but do not over tighten.
7.Check the brakes thoroughly before use.
NOTE
: The brakes are factory set, and if assembled correctly do not need adjusting prior to use. To check;
Apply and release the parking brake on each side 10 times. (Push brake lever down to lock, lift to release)
The brake should grip the wheel and prevent any movement when applied. When released, the gap
between the brake moulding and the wheel should be between 3 to 4 mm. If either of the above conditions
is not correct adjust the brakes as detailed in the maintenance section, and re-check.
8. Check all other nuts, bolts and screws are tightly fastened.
