IDEC Micro HG2G-5F Series, Instruction Sheet

Page: 59 / 72

23
・
Place the HG4G/3G, HG2G-5F in a panel cut-out and fasten with the attached mounting
clips at four places of the top and bottom side to a specified torque uniformly.
・
The HG4G, HG2G-5F has the mounting clip positions not only on the top and bottom side
but also on the left and right side. But when fasten with the attached mounting clips at
the left and right side, the HG4G, HG2G-5F may impair the waterproof, the vibration
resistance, and the shock resistance characteristics.
TOP
BOTTOM
Mounting Clip Position ex) HG3G-8 (8.4 inch)
Unit : N
･
m
Type Specified Torque
HG4G 0.5 to 0.6
HG3G-A 0.5 to 0.6
HG3G-8 0.5 to 0.6
HG2G-5F 0.2 to 0.3
●
Do not tighten excessively, otherwise the HG4G/3G, HG2G-5F may warp and cause
wrinkle on the display, or impair the waterproof characteristics.
●
If the mounting clips are tightened obliquely to the panel, the HG4G/3G, HG2G-5F may
fall off the panel.
●
When installing the HG4G/3G, HG2G-5F into a panel cut-out, make sure that the gasket
is not twisted. Especially when re-installing, take special care because any twists in the
gasket will impair the waterproof characteristics.
Panel
Mounting Clip