IDEAL MSC-13K-B, Manual

Page: 20 / 46

20
Nov. 2021
MSC-13K
5. LIFTING OPERATION INSTRUCTIONS
The assembled lifting system must be checked for correct working and
adjustments and a complete operational test should be carried out by using a
typical vehicle.
Remarks
:
-When using this lifting system, leave a space for a 24” (600mm) wide passage
around the lifting system, which can serve as escape route.
-Before using the Portable Lifting Columns, ensure that the maximum load for
each lifting column is not more than 13,200 lbs.
-Ensure that before use, the lifting system is placed vertically seen from the
sides as well as from the front.
-Make sure that the pallet jack mechanism is fully lowered before lifting a vehicle.
5.1 PREPARATION & IMPORTANT NOTICE
1. Place all the four of lifting columns around the vehicle as in Fig.5.
2. Ensure that the fork of each lifting column is slid around the wheel as far
as possible. ( The forks shall have been adjusted as in Fig.6 )
3. Move the columns’ forks under the wheel.
4. Lower the pallet jack mechanism by releasing the lever inside the handle
bar.
5. Make sure all of the power switches on the control boxes are set to 0
(OFF).
6. Make sure that the Emergency Release buttons are unlocked on all the
lifting columns.
7. Set all the power switches to left position (ON). (Main column to be the
last one)
8. Press button START on the main control box to run the software.
9. Set the mode to be WHEEL / SINGLE by pressing button [11].