Chapter 2
Test Setup Procedures
Table 2-1: Autotest Preference Options (continued)
Option Action
Enable Tera to
Tera Mode
LANTEK is set to default with Tera-to-Tera enable mode.
In this mode, LANTEK firmware assumes that there is Tera-to-Tera
patchcords connected and will treat an Autotest as a Cat 7 Autotest.
If unselected, LANTEK firmware will assume that there is Tera-to-RJ45
patchcords attached and the Autotest will be treated as a Cat 6 Autotest.
Enable Wiremap
on Failed Autotest
Mode dictates whether or not the LANTEK will automatically enter the advanced
failure analysis when an Autotest fails.
CONTRAST
1.
Select Contrast on the Preferences screen. Press ENTER. The Contrast screen
appears.
2.
Select
/
or
/
to adjust the screen contrast.
Figure 2-4: Contrast Screen
3.
Press ENTER to save or ESCAPE to exit.
2-3
www.vemco.pl
