IDEAL INDUSTRIES CREE LIGHTNING ZR-RK Series Installation Instructions Manual Download Page 4

Page: 4 / 15

4 of 5

LPN00825X0003A0_A

TROUBLESHOOTING:

Out of the box, if the light does not turn on
when power is applied:

• Check Wiring with power off
• If wired correctly, check to see

if Blue LED has a double blink
pattern. If not, please proceed to
RESET procedure.

• If Blue LED is blinking, then perform

a RESET (See RESET section).

• If Blue LED is on solid or off, call

Cree Lighting Customer Service.

• If you have done a RESET, and the

light is still off, call Cree Customer
Service.

If light is unresponsive, use Cree
Lighting Configuration Tool to verify
configuration.

EMERGENCY DRIVER CHECK

NOTE:

For short-term testing of the

emergency function, the battery must
be charged for at least one hour. The
emergency driver must be charged for at
least 24 hours before conducting a long-
term test.

STEP 1:

When AC power is applied, the charging
indicator light is illuminated, indicating
the battery is being charged. When power
fails, the emergency driver automatically
switches to emergency power, operating the
LED array. When AC power is restored, the
emergency driver returns to the charging
mode.

STEP 2:

Although no routine maintenance is
required to keep the emergency driver
functional, it should be checked periodically
to ensure that it is working. The following
schedule is recommended:

• Visually inspect the charging

indicator light monthly. It should be

illuminated.

• Test the emergency operation of

the fixture at 30-day intervals for a
minimum of 30 seconds. When the
test switch is depressed, the LED
array should operate.

• Conduct a 90-minute discharge test

once a year. The LED array should
operate for at least 90 minutes.

If the luminaire fails any of these checks,
consult service personnel.
REFER ANY SERVICING INDICATED
BY THESE CHECKS TO QUALIFIED
PERSONNEL
EMERGENCY DRIVER AND AC DRIVER
MUST BE FED FROM THE SAME BRANCH
CIRCUIT.

FCC NOTICE

CAUTION:

Changes or modifications not

expressly approved could void your authority
to use this equipment.
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found
to comply with the limits for a Class A
digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference when the equipment is
operated in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruction
manual, may cause harmful interference
to radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference in which case
the user will be required to correct the
interference at his own expense.

CAN ICES-005 (A)/NMB-005 (A)
Le présent appareil est conforme aux
CNR d’Industrie Canada applicables
aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne
doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en
compromettre le fonctionnement.

RF EXPOSURE NOTICE:

To comply with the FCC/IC RF exposure
compliance requirements, this device and
its antenna must not be co-located or
operating to conjunction with any other
antenna or transmitter.
This equipment shall be installed and
operated with minimum distance 5 cm
between the radiator & your body. No other
antenna is authorized for use with this
product.
Pour correspond aux requis d’exposition au
FCC/IC RF, cet appareil et son antenne ne
doivent etre localisee tout pret ou operer
en conjunction ave d’autres antennes
ou transmetteurs. Cet equipement doit
etre installe et opere avec une distance
minimum 5 cm entre l’emetteur et votre
corps. Aucune autre antenne externe n’est
autorisee a etre utilise avec ce produit.