Ideal Boilers FF 350, Installation And Servicing

Page: 15 / 40

Classic FF -
Propane Installation & Servicing
15
INSTALLATION
REAR FLUE OUTLET
14 CUTTING THE FLUE - wall thicknesses of 114 to 600mm
Note.
If the stand-off brackets are used it is essential that
30mm is added to the measured wall thickness when
marking the flue, (to allow for the thickness of the brackets).
1. Measure and note the wall thickness 'X'.
2. Mark the wall thickness onto the flue .
3. To ensure the tube is cut square, mark the flue all the way
round.
4. Cut to length 'X', using the cardboard ring for support.
5. Remove cardboard ring and remove any burrs.
1. Fit the boiler sealing ring inside the outer flue duct.
Ensure boiler sealing ring is fully engaged.
Ensure the notch aligns with the groove on the outer flue
duct. This ensures correct alignment of the flue terminal.
15 FITTING BOILER SEALING RING TO THE FLUE
2. Drill 3 holes 3.2mm (
1/8
") dia. through the outer flue duct
and boiler sealing ring.
Do NOT drill the inner flue
duct
.
3. Insert the self tapping screws, provided, in order to fix the
boiler sealing ring in position.
4. Stick the self adhesive
foam strip, provided in the
hardware pack, onto the
flue immediately behind the
boiler sealing ring.
1. Insert the flue extension tube into the flue assembly.
2. Insert the flue assembly through the hole sufficiently far
enough to allow the rubber seal to unfold completely
and form an adequate seal on the outside wall.
3. Ensure the notch is at the top. This will aid the location
of the studs into the boiler back panel.
1. Fix the mounting plate to the wall with the No.14 x 50mm
wood screws.
2. If the down ward routing of pipes is required, then the
downward routing pipe brackets and M8 spacer
(supplied in the Downward Piping Kit) should be fitted to
the wall mounting plate now.
3. Fit the bottom 2 screws to secure the bracket(s) to the
wall, through the wall mounting plate.
4. Check with a spirit level that the plate is vertical.
16 FITTING THE FLUE ASSEMBLY
17 WALL MOUNTING PLATE