www.idatalink.com
For technical assistance, contact your distributor or visit www.idatalink.com/support
© 2007 ADS Inc.
install guide
Version française disponible en ligne au www.idatalink.com
doorlock interface
chrysler / dodge / Jeep
Page 7 of 11
ADS-DLSL-CH1
20071214
www.idatalink.com
For technical assistance, contact your distributor or visit www.idatalink.com/support
© 2007 ADS Inc.
NOTICE:
the manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself
or to the installed device. this device must be installed by a certified technician. this guide has been written for properly trained technicians; a certain level of skill &
knowledge is therefore assumed. please review the installation guide carefully before beginning any work.
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
LOCK (-) INPUT - GREEN/BLACK
UNLOCK (-) INPUT - BLUE/BLACK
(NC) RED/WHITE
(NC) BROWN
(NC) PURPLE/YELLOW
(NC) PURPLE/BLACK
(NC) WHITE
(NC) BLACK/WHITE
DOOR & TRUNK STATUS (-) OUTPUT - GREEN
TACH OUTPUT (AC) - PURPLE/WHITE
BROWN/RED - GROUND
BROWN/YELLOW - KEYSENSE(-) OUTPUT
ORANGE/BLACK (NC)
ORANGE/WHITE (NC)
ORANGE - DATA (J1850)
PINK/BLACK (NC)
PINK - IGNITION (+) INPUT
YELLOW/BLACK (NC)
YELLOW/RED (NC)
YELLOW (NC)
BLUE/WHITE
(NC) NO WIRE
GROUND - BLACK
12V - RED
CONNECT TO PIN #2 OF OBDII
CONNECTOR LOCATED UNDER
DRIVER SIDE DASHBOARD
***** OPTIONAL *****
TRANSPONDER LOOP
ADS-RNG-C1 IS REQUIRED
FOR TRANSPONDER BYPASS
APPLICATION.
LIGHT BLUE (KEYSENSE)
IDATALINK (RS232) PORT
REQUIRED ON REMOTE STARTER.
IF THE PORT IS UNAVAILABLE
USE STANDARD WIRING METHOD.
LEGEND
Wiring connections not required
when installed in iDataLink mode
IDATALINK
CONNECT EITHER
IDATALINK
OR
STANDARD WIRING
GROUND-OUTPUT WHEN RUNNING (-)
REMOTE
STARTER
OR
SECURITY
SYSTEM
OR
KEYLESS
ENTRY
TYPE 6
wIrINg DIAgrAM
To DeTerMINe If VehICle Is eQUIPPeD wITh oeM AlArM
PROCEDURE wITH OEM KEYFOB
1. CLOSE hatch and hood.
2. CLOSE all doors and SIT at the driver seat.
3. PRESS lock on the OEM KEYFOB twice.
4. WAIT 60 seconds.
5. OPEN the driver’s door. If the alarm goes off, the vehicle is
equipped with an OEM alarm.
PROCeduRe withOut OeM KeyFOB
1. OPEN driver’s door window.
2. CLOSE hatch and hood.
3. CLOSE all doors including driver’s door
4. LOCK the driver’s door twice using the key in driver’s door
key cylinder.
5. WAIT 60 seconds.
6. OPEN the driver’s door using the inside door handle by passing
your arm thru the opened window. If the alarm goes off, the ve-
hicle is equipped with an OEM alarm.
Num. de Doc.: ##00130##
