www.idatalink.com
For technical assistance, contact your distributor or visit www.idatalink.com/support
© 2007 ADS Inc.
install guide
Version française disponible en ligne au www.idatalink.com
doorlock interface
chrysler / dodge / Jeep
Page 9 of 11
ADS-DLSL-CH1
20071214
www.idatalink.com
For technical assistance, contact your distributor or visit www.idatalink.com/support
© 2007 ADS Inc.
NOTICE:
the manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself
or to the installed device. this device must be installed by a certified technician. this guide has been written for properly trained technicians; a certain level of skill &
knowledge is therefore assumed. please review the installation guide carefully before beginning any work.
1
2
3
Locate the Immobilizer security light. It is either a round red indicator in the cluster or a red led on top of the dashboard.
Locate the transponder on the antenna.
Fold the harness as shown below.
TRANSPONDER PRE-PROGRAMMING
20
40
60
80
100
120
LOCATE
THE SECURITY LIGHT
1
3
Wait approximately 15 seconds
for security light to flash, indicating
you have accessed “Learning mode”.
A warning chime will also be heard.
Turn the ignition to the “OFF” position
and remove key from ignition.
Hold the transponder to the ignition
cylinder and power the main ignition
using a 10 Amp fused test lead.
(Note: If you encounter power loss
during this step, you will need to exit
learning mode and restart transponder
programming from step 1.
The security light will start flashing,
indicating you are now in programming
mode.
DO NOT INTERRUPT IGNITION until the
security light stops flashing.
Insert the first vehicle key into the ignition.
Turn the ignition to the “ON” position.
Security light on cluster will illuminate.
Once, the security light turns off,
turn the ignition to the “OFF” position
and remove key from ignition cylinder.
TRANSPONDER PROGRAMMING
ON
2
Insert the second vehicle key into the
ignition. Turn the ignition to the “ON”
position.
Security light will illuminate
and then turn off.
The security light will turn on solid and
then turn off. The chime will be heard
once again.
Transponder programming is now
completed.
ON
2nd KEY
OFF
OFF
IMPORTANT: Both keys are required to complete the
programming procedure. A maximum of 5 second delay
between each step is permitted. If the delay is exceeded, the
vehicle will not allow programming to continue.
20
40
60
80
100
120
SECURITY LIGHT
ON THEN OFF
SECURITY LIGHT OFF
FLASHES
FLASHES
SOLID THEN OFF
HOLD TO CYLINDER
12V
IGNITION
10 AMPS
ProgrAMMINg ProCeDUre
Num. de Doc.: ##00130##
