ID Photonics CoBrite Series, User Manual

Page: 17 / 44

___________________________________________________________________
Co Brite
DX1
User Manual
16
4.3 Ethernet Port (CoBrite
DX4
or CoBrite
MX
only)
This port is accessed using Telnet protocol. The most common freeware telnet Tool
is “Putty” which can be easily set up to connect to the Ethernet Port. Putty can be
found on the installation medium.
If the standard GUI is used, there is no dedicated Telnet functionality needed as it is
built into the software. Just enter the IP Address and the GUI program will connect.
Note : The standard IP address of this port is: 192.168.0.1, Port# 10001
4.3.1 Changing the IP address
The IP address can be changed using the Host GUI provided with the system in the
main window. Click <Configuration> - <IP Address> to start the configuration
process. This dialog is only available if the GUI is currently connected via Ethernet. In
the pop up window, the current IP address is shown as default
Note : Configuring a new Address is only possible if the current target IP is
reachable and the GUI is connected via Ethernet.
. If you want to configure a different interface, pre ss “Scan for Devices” to scan for
active instruments in your network. Depending on configuration of your network, the
device might not be found but still be reachable. In this case, enter the IP Address
manually and press ok.
IP and Ethernet MAC addresses and instruments found are displayed in a dropdown
list. Select the IP address of the instrument that you wish to change by pressing
“UseDevice”.