ID Photonics CoBrite Series, User Manual

Page: 16 / 44

___________________________________________________________________
15
Co Brite
DX1
User’s Manual
4 Interfaces
4.1 Available Interfaces for different chassis variants
4.1.1 CoBrite
DX1
This chassis provides connectivity via USB located at the rear side of the instrument.
See section 5.3.2 for details on how to connect via USB Port using the supplied GUI.
4.1.2 CoBrite
MX
This chassis series provide connectivity via USB located at the faceplate; 1 USB &
Ethernet located at the rear side of the instrument. See section 5.3.2 for details on
how to connect via USB Port using the supplied GUI.
See section 5.3.1 for details on how to connect via Ethernet Port using the supplied
GUI.
4.2 USB Port
USB ports are available on all chassis variants and offer identical functionality in case
several USB Ports are available on a chassis.
Note : Please install the GUI including according drivers before using these
ports as there are special drivers required to operate them!
If the standard GUI is used to connect to those Ports, it will be automatically detected
by the GUI software. See section 5.3.2 for details.
4.2.1 Usage of USB Port for custom remote control
USB ports will install as virtual COM Ports to the attached computer and therefore
allow quick and easy access by any standard Terminal Program such as the
Windows built in “Hyper Terminal”.
Note : Use the following settings for operation:
Serial speed: 115.200
Data format: 8N1 (= 8 bits, no parity bit, 1 stop bit)
Flow control must be off