ICWUSA.com, Inc.
If you have any questions, please call 1-800-558-4435
ELITE DOUBLE ARM
ELITE DOUBLE ARM INSTRUCTIONS - rev 11/01/2013 mf
page 2
REMOVE ELITE
ARM COVERS
TOP COVERS:
Remove the
long arm cover
by unscrewing
the two 1/4”
long 6-32
fl athead screws
in the center of
the cover using
a philips head
screwdriver.
END COVERS:
Remove the
end covers by
unscrewing the two
3/4” long 10-24
fl athead screws
using a philips
head screwdriver.
CENTER COVER:
Remove the
center cover by
unscrewing the
four 3/4” long
10-24 fl athead
screws using
a philips head
screwdriver.
ATTACH ELITE ARM TO WALL MOUNT
Pass 3/8 bolt with bearing
assembly through wall
mount ear and into end
of Elite Arm. Secure Elite
Arm over wall mount
using split lock washer
and nylock nut with 9/16
wrench provided and
5mm hex key.
9/16 wrench
(provided)
5mm
Black plastic beauty cap
Bearing
assembly
MANAGE CABLES THROUGH ARM
Extend the arm straight out and
lay all the cables for your monitor,
keyboard and mouse in the
channel on top of the arms.
Lay cables evenly around
adjuster with wire loom
on each side.
Wire tie cables around
adjuster, securing the
cords and the wire loom.
Leave some slack.
Add provided wire clips,
weaving through wire loom
to secure cables.
NOTE:
YOU
MUST
LEAVE SOME SLACK IN
THE CABLES TO ALLOW
FOR ARM MOVEMENT.
Add wire clips to end
of arms as well.
ADJUST ROTATION LIMITS - WALL MOUNT
The rotation limits for
the arm are set by
placing the stop pins in
the hole corresponding
to where you want the
arm to stop. The stop
pin then collides with
the stop block on the
front of the wall mount
ear, stopping the arm.
The stop pins can be
removed and set by
hand.
Stop Pin
Stop Pin
Stop Block
IF YOU ORDERED THE ROTATION LIMITER ACCESSORY
