22
PRX-TSEC
tSec Multi-Technology Card Reader
Installation Manual | June 2017
7.12
Intelligent Tamper
Enabling the intelligent reader tamper mode will force the card reader to check in to the device it is connected to
every 30 seconds.
In RS-485 programming mode, the following options are available by pressing the M key from the main
menu.
In 125kHz programming mode, the following options are available by badging the programming card four
times to enter Address 4.
Function
125kHz Setting
RS-485 Setting
Disabled
1
1
Enabled
2
2
i
Only enable Intelligent Reader Tamper Mode if the access control system or reader interface supports
intelligent tamper operation.
7.13
Factory Reset
Applies to RS-485 programming mode only.
This resets all settings in the device excluding custom encryption keys. To reset the reader, press the O key
from the main menu.
7.14
Output Mode
Applies to RS-485 programming mode only.
The Output Mode defines the output format of the reader. Three formats are available - Wiegand, ICT Smart or
Custom RS-485. To change the Output Mode, press the L key from the main menu.
7.15
Clone Card Notify
Clone Card Notify enables the reader to notify the reader expander if a card presented is a non-standard Mifare
compatible card. This setting is only supported when using RS-485 configuration and requires the Clone Card
Reading option to be enabled.
To toggle the Clone Card Notify option, press the 1 key.
7.16
Clone Card Reading
The Clone Card Reading option determines whether non-standard Mifare compatible cards are read by the
reader.
To toggle the Clone Card Reading option, press the 2 key.
7.17
Clone Card Destroy
If this setting is enabled and a non-standard Mifare compatible card is presented, the reader modifies the card
so it cannot be read.
To toggle Clone Card Destroy, press the 3 key.