PRX-TSEC
tSec Multi-Technology Card Reader
Installation Manual | June 2017
19
7.6
Interface
When the Output Mode of the reader is set to Wiegand, interface programming configures how the reader send
information to the connected system. When the Output Mode of the reader is set to Custom485 the interface
programming defines the data format used with the raw format specifier.
The interface programming configures how the Reader sends information to the connected system.
In RS-485 programming mode, press the D key to cycle through the available options.
In 125kHz programming mode, the following options are available by badging the programming card twice
to enter Address 2.
Setting
125kHz Setting
Description
26 Bit Wiegand
1
Standard 26 Bit Wiegand data sent on the D0 and D1 data
lines. Truncation of site/facility codes will occur for any card
or tag programmed with a site code above 255.
27 Bit Tecom Wiegand 6
Tecom formatted 27 Bit Wiegand sent on the D0 and D1
data lines. Truncation of site/facility codes will occur for any
card or tag programmed with a site code above 2048.
32 Bit Wiegand
-
Standard 32 Bit Wiegand data sent on the D0 and D1 data
lines. No truncation will typically occur however it is
recommended to use industry standard 34 Bit. 32 Bit
Wiegand has no parity or other error checking.
34 Bit Wiegand
2
Standard 34 Bit Wiegand data sent on the D0 and D1 data
lines.
HOTEL
-
Send card information in HOTEL format.
37 Bit Wiegand
3
Standard 37 Bit Wiegand data sent on the D0 and D1 data
lines.
37 Bit Wiegand
Alternate Format
4
Alternate 37 Bit Wiegand data sent on the D0 and D1 data
lines.
64 Bit Wiegand
-
Standard 64 Bit Wiegand data sent on the D0 and D1 data
lines.
Auto
-
When a card is badged, the number of bits sent is
determined by the information encoded on the card.
7.7
LED Function
Applies to RS-485 programming mode only.
The LED function allows the configuration of dual or single line led operation. The default is single LED mode,
Blue On.
In RS-485 programming mode, press the E key to cycle through the available options.
In 125kHz programming mode, the following options are available by badging the programming card three
times to enter Address 3.
Setting
125kHz Setting
Description
Dual
1
Grounding the orange wire will enable the green LED.
Grounding the brown wire will enable the blue LED.
Blue On
2
The blue LED is on by default. Grounding the brown wire
turns off the blue LED and turns on the green LED.
Green On
3
The green LED is on by default. Grounding the brown wire
turns off the green LED and turns on the blue LED.