Innovative Circuit Technology Ltd.
19
Network setup
Use this page to configure the network settings for the panel. Click on the Save
Settings button at the bottom of the page to save any changes and re-boot the
panel.
NOTE
:
Saving any changes to the network settings will cause the panel to re-boot, cycling power
to all outputs.
Network:
MAC Address:
Displays the MAC address assigned to the panel. It is also
shown on line four of the LCD Network Status screen.
Enable DHCP
: Turn on this setting if the network uses a DHCP server to
automatically assign IP addresses. (Enabled as default setting). To manually
assign a static IP address to the unit uncheck this box, then set the following
parameters.
IP Address
: Specify a unique IP address for the unit.
Subnet Mask:
Specify the mask for the subnet the panel is located on
Gateway:
Specify the IP address of the default router (Gateway) used for
connecting attached devices to different networks.
Primary DNS
: Specify the IP address of the Primary DNS Server for the
network.
Secondary DNS
: Specify the IP address of the Secondary DNS Server for the
network.
Web Server:
CAUTION
:
Changing the web server port numbers may cause loss of communication with
the panel
The following ports may be changed within a range of 1 to 65565, if required.
HTTP Port
: This port is used for HTTP traffic between the panel and the
browser. The default HTTP port is
80
. If this is changed, the new HTTP Port