ICS TSS 15, Operator'S Manual

Page: 5 / 12

TSS Vacuum OPERATOR’S MANUAL
5
F/N 71335 Oct 07 © 2007 ICS, Blount Inc.
SAFETY
GENERAL SAFETY PRECAUTIONS
• Always wear protective clothing, including hard hat, eye protection, hearing protection, and
gloves.
• Avoid loose fitting clothing.
• Perform safety checks before starting each day.
• Always operate tool with solid footing and with both hands on cut-off saw.
• Remove or control slurry to prevent slippery conditions while cutting.
• Be sure there are no obstructions (plumbing, electrical conduit, air ducts) and no unnecessary
people present.
• Set up a well-marked safety zone with a roped boundary and clear signs.
• Provide adequate ventilation when working in an enclosed area. Breathing exhaust gases is
dangerous.
• To avoid electrical shock when operatng the TSS-15/55 outdoors or on wet surfaces the machine
must be properly grounded. The TSS-15/55 is equipped with an approved three conductor power
cord grounding plug to fit a nominal 120 volt circuit shown in figure X. No adaptor should be used
with this mcahine.