ICS PCI-WDT 500, Product Manual

Page: 13 / 44

Manual Number: 00650-144-1 Page 4
PCI-WDT 500/501 Manual
If you are not using Windows95, or if your installation of Windows95 does not detect the new
hardware you installed, run PCIFind.EXE to determine the base address that the computer as-
signed.
The base address assigned by BIOS or the operating system can change each time new hardware is
installed into or removed from the computer. Please recheck PCIFind or Device Manager if the
hardware configuration is changed.
Input/Output Connections
Connections are made via a 25-pin connector on the card mounting bracket. Also, there is a six-
terminal terminal block. Signal assignments are listed in Section 6 of this manual.
To ensure that there is minimum susceptibility to EMI and minimum radiation, it is important that
the card mounting bracket be properly screwed into place and that there be a positive chassis
ground. Also, proper EMI cabling techniques (cable connect to chassis ground at the aperture,
shielded twisted-pair wiring, etc) be used for the input/output wiring.
Connecting the Reset Line
After inserting the power-good line into the clamp, compress the metal bar with pliers and close the
protective cover.